The back side panel is where the connectors are for external equipment including the Power Supply, the system that receives the Model 1's audio output, the volume control and the power switch.
1) Turn the power switch OFF. Plug the included power supply into a normal 110VAC wall outlet (a quality surge suppressor is strongly recommended) and the 15VDC jack on the Sonorous. Only use the power pack provided with the unit.
2) Connect the 1K audio output jack to the MOH (Music-On-Hold) audio input of your KSU/PBX Telephone System using the included RCA-to-RCA cable. If the system does not have an RCA-style input, use the included RCA to 1/8 inch adapter.
3) Turn the power switch on. After a short self-test, the Status LED turns to a blinking Green. Press the CD open/close button, place the CD into the drawer, then press the open/close button. The Model 1 detects the presence of the CD, the Status LED turns to a blinking Orange, then begins the load process automatically. After all messages are successfully loaded, the Status LED turns to a solid Green. Messages only play after they are loaded into the Flash memory.
Important: It is not necessary to leave the CD in the unit after loading. Since the Model 1 uses non-volatile flash memory, messages are not erased during power outages or when the unit is unplugged or turned off. If you do decide to remove the CD, LEAVE IT OUT. Every time you insert a CD with the power switch on, all messages are erased and the CD load process begins.
NOTE: Never eject the CD while it is loading.
You can listen to the messages via the internal monitor speaker by pressing the monitor switch. This is useful to verify proper operation of the Model 1. Pressing the monitor switch again turns off the speaker.
4) The Volume Knob is used to adjust the volume to a comfortable level, while listening on hold. The Model 1 plays back all loaded music and messages over your MOH port continuously.
Wall Mounting: Using the screw holes on the unit as a guide, secure four screws through the unit into the wall where you want to mount the unit. Consider the weight of the Sonorous when choosing a mounting wall. Make sure the wall’s construction is sufficiently strong to support the weight of the unit securely. Make sure all 4 screws are driven into studs or other sturdy supports, not just into plain drywall. The unit may be installed in any direction; however, be sure that the area in front of the CD-ROM drawer is clear, allowing it to open completely.
Flat Surface Mounting: Secure the four included rubber feet to the bottom of the unit near the screw holes in each corner. Place the unit on a sturdy table, away from any obstructions that may disrupt its mounting. The unit may be installed in any direction; however, be sure that the area in front of the CD-ROM drawer is clear, allowing it to open completely.
If you have trouble installing or operating the Model 1, please call Technical Support at 888.864.2402, or send an email to support@onhold.ws.
|
